TOS Helm for AA/DST
#41
Posted 12 April 2012 - 08:11 PM
Here is the mold with a casting.
Now with flashing and air vents removed as well as trimmed down to peg.
#42
Posted 12 April 2012 - 10:06 PM
#43
Posted 13 April 2012 - 04:11 PM
I should be able to start the mold making part sometime tonight!
#44
Posted 14 April 2012 - 03:27 AM
#45
Posted 20 April 2012 - 07:03 PM
#46
Posted 21 April 2012 - 12:08 AM
#47
Posted 21 April 2012 - 07:24 PM
#48
Posted 23 April 2012 - 12:24 PM
#49
Posted 26 April 2012 - 11:44 AM
#50
Posted 26 April 2012 - 01:12 PM
#51
Posted 23 April 2013 - 09:33 PM
It's been a while since I put any work in on this project. Now that I have reclaimed my workspace I'm going to be making some more progress, all be it probably a little slower than before. After looking through everything I think I will be making a new mold for the chairs and I don't think I will eventually use the castings I made so far. In order to recoup some of the cost of a new mold and to give some of you a preview of what these will eventually look like I am working on getting these to a somewhat presentable state and I will offer them for sale $15 shipped in US (International may vary). These are still pretty rough but with an action figure sitting in them they don't look too bad. If anyone is interested just send me a PM. I have 3 so far, but may have a few more later see below.
#52
Posted 24 April 2013 - 07:38 AM
Wow man good job on the chairs. are you going to build a full bridge?
#53
Posted 25 April 2013 - 09:09 PM
Wow man good job on the chairs. are you going to build a full bridge?
That is my ultimate plan. Once I get the helm completed I want to build the surrounding bridge modules. The design of this bridge will enable me to mold one piece that will be interchangeable for each of the stations.
#54
Posted 02 May 2013 - 07:08 AM
That is my ultimate plan. Once I get the helm completed I want to build the surrounding bridge modules. The design of this bridge will enable me to mold one piece that will be interchangeable for each of the stations.
i was going to mold the walls for the Defiant but it was going to be way too much money for all that rubber & res.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users